800-622-6717

Request a Quote

Powder Coat Process

RIMM-KLEEN SYSTEMS uses the same process in coating “new” rims/wheels.

One or two step paint process available.

Additional Services

  • Swap programs available
  • Stainless steel valve stems added for additional charge
  • Used rims are available for purchase

Step 1: Prepare rim for paint

  • Remove all rust, scale and old paint
  • Rim is then cleaned to base metal and inspected for cracks or bends in bead and worn bolt holes.
  • Faulty rims can then be removed from service before they can cause serious problems.

Step 2: (Optional) Apply coat of Zinc Rich Primer

  • Primer gives an added layer of protection against rust before color is added.

Step 3: Apply color to rim

  • Using a charged Powder coating system, a color coat is applied to the rim.
  • This environmentally safe procedure applies powder in uniform coats with no runs.
  • This process insures full coverage without exceeding allowable thickness.
  • Available in Standard colors: White, Grey, Black.
  • Premium colors available such as: Silver, Red, Orange, Yellow, and Blue.

Step 4: Rim is run through the Bake-A-Rim oven for complete cure

  • Rims bake in oven for 15 minutes
  • Results in the same coating and look as a new wheel
  • The finish is chip resistant, resists petroleum products and is 1500 hour salt spray tested.
  • This finish lasts up to 40% longer than traditional paint finish.
  • Ready to remount in less than 1 hour.